A pool skimmer helps get rid of dirt and debris in the water. However, over time, they can become clogged, preventing them from providing maximum performance. To prevent this, regularly inspect the skimmer and remove the blockage.

The water can become dirty and unsanitary if the pool skimmers are not working. With this, keep reading, and we will tell you how you can unclog the skimmer line.

If you’re looking for a top-of-the-line pool cleaner, the Maytronics Dolphin Robotic Pool Cleaner is one of the best on the market. This machine is capable of tackling even the most difficult pools thanks to its suction capabilities and brush system. Plus, its automated operation means you can spend more time enjoying your summertime sun and less time cleaning up after it with Maytronics.


A step-by-step guide on how to unclog the pool skimmer line

You don’t need to be a professional to learn the basics of unclogging a pool skimmer line. You will need essential tools, and the steps will be simple. These are the things you need to do to get rid of the clog.

  1. Turn off the pool pump.

The first thing to do to unclog the pool skimmer line is to find the pool pump and turn it off. This is crucial for your safety, so remember to do it before starting work. To prevent the pump from creating accidentally, it would be best to cut off the main power supply.

  1. Remove the cover

Now, place the skimmer in the pool and remove the cover. It can be held in place with a twist fastener or screws. It is located on the side of the pool, usually rectangular or round. There is also a part attached to the pool deck for the part where you walk.

  1. Raise the basket

Once the skimmer is off, do a quick scan of the skimmer line for any sharp objects. Once it is clear of hazards, find the skimmer basket handle. After pulling the basket, empty the contents.

  1. Inspect the basket support

Now that the basket is out inspect the lid. Cracks can also collect debris and cause clogs. To do this, you will need a climbing snake. Pass it through the pipe. If it stops suddenly, there is most likely a blockage. If there is an obstruction, coil the snake until it comes free. You may need to repeat it if the backup is immense. Pull the plumber’s snake and get rid of the debris.

  1. Use a garden hose

You can also use a garden hose as an alternative to a plumber’s snake. Connect it to a water supply and turn it on. Let the water flow back to the inlet. Look for any debris thrown up by the pressure of the water. Get it out of port.

  1. Return the skimmer basket

After getting rid of the clog, it’s time to return the skimmer basket. Put all the pieces back in reverse order based on what you removed earlier, and make sure they fit snugly. The last thing to put back on is the skimmer lid. Make sure it is screwed on tight or that you rotate the cap correctly.

  1. Run the pump

Once the skimmer basket and cover are in place, it’s time to turn on the pump. Now you can enjoy the pool again. Please pay close attention to dirt and debris, ensuring the skimmer is doing its job correctly.

Reasons Why Pool Skimmers Don’t Work

The main reason why the pool skimmer is not working is that it could be clogged. When this happens, it doesn’t get rid of dirt and debris, affecting the quality of the pool’s water. However, there are other possible reasons why it doesn’t work, including the following:

  • There needs to be more water in the pool. The water must reach the level of the skimmer for it to work. Otherwise, it won’t suck anything.
  • Problems with the pool’s filtration system can also prevent the pool skimmer from working correctly. Without the suction power of the filter, the debris in the pool skimmer basket will end up back in the water.
  • The circulation pump could have a problem. The skimmer uses the suction from the circulation pump, so when the circulation pump is not working, the skimmer may also have problems.

More Topic:-

Leave a Reply

Your email address will not be published. Required fields are marked *